Cisco method manual nvram

Note The Cisco CGR router must be running Cisco IOS Release (4)M or higher to run the switch module. After the Ethernet switch module is installed on the router, you see a new Gigabit Ethernet interface 0/x/0 (where x is the slot numb er) recognized by the Cisco IOS. The output shown in Table 6 is taken after two.  · Ethernet0 YES NVRAM down up Serial2 YES manual down down Serial3 unassigned YES unset administratively down down 1)How do i change the method from manual to NVRAM 2)I Cant seem to bring up serial2 when i run no shut nothing happens Comment. Method Whether the IP address has been saved in NVRAM. If you have set the IP address for the interface in the CLI or Web Management Interface, but have not saved the configuration, the entry for the interface in the Method field is "manual". Status The link status of the interface.

Step 1 Enter erase nvram: to erase all NVRAM files including the startup configuration. Note The erase nvram command does not erase a static IP address. Step 2 Follow the step below to erase a static IP address and subnet mask. Method. The method field has the following possible values: • RARP or SLARP—Reverse Address Resolution Protocol (RARP) or Serial Line Address Resolution Protocol (SLARP) request • BOOTP—Bootstrap protocol • TFTP—Configuration file obtained from TFTP server • manual—Manually changed by CLI command • NVRAM—Configuration file in NVRAM. Both TFTP and manual cut-and-paste enrollment methods are manual enrollment processes, requiring user input. Cisco IOS Suite-B Support for Certificate Enrollment for a PKI Suite-B requirements comprise of four user interface suites of cryptographic algorithms for use with IKE and IPSec that are described in RFC

Method Status Protocol FastEthernet0/0 YES NVRAM up up Serial1/0 YES manual up up Serial1/1 unassigned YES unset. 2 mar Method Status Protocol Ethernet0 YES NVRAM up up. Ethernet1 unassigned YES unset administratively down down. Clear the configuration on the switch using the procedure in Appendix 1. Switch#show version. What is the Cisco IOS version that the switch is running?